Laboratuvar elekler

Stainless steel. In accordance to ISO 3310-1:2016 and ASTM E11:2009.

Test materials can be used to check analytical sieves between the schedulded calibration dates and to demonstrate the presence of the required properties, as well as the suitability of analytical sieves. A test material for analytical sieves with frequent mesh widths ( 2.0mm - 1.0mm - 0.5mm - 0.25mm - 0.125mm ).

• Pack of 3 bottles, 202g each
• Grain size : from 0.125mm to 2.00mm
• Data sheet for the use of traceability for analytical sieves

Thermo-fixed Polyamide (Nylon) mesh is temperature stable from -40 °C to 115 °C. In water from 95 °C to 100 °C. Stability in acids is limited and dependent on concentration and temperature. Nylon exhibits outstanding stability in alkalis, including sodium and potassium solutions. Its chemical behaviour with respect to organic solvents is moderate to good. Minimum mesh width: 102 cm, Length: 1 m

Other sizes available on request.

Thermo-fixed PE mesh with temperature resistance from -75 °C to 150 °C (short). For long term heating max. 125 °C. Resistant to acids but not alkalis.
Dimensions: Minimum width 102 cm, Length 100 cm.

Other sizes available on request.

For difficult to separate materials which require dry sieving. Different aids are used according to mesh size.

With welded seam (heat resistant up to 170 °C). Diameter: 100 mm.
Height 45 mm.

With soft solder seam (temperature resistant to 170°C). 100mm diameter. Height 45mm.

With soft solder seam (temperature resistant to 170øC).
100mm diameter.
Height 45mm.

With soft solder seam (temperature resistant up to 170 °C).
Diameter: 200 mm.