Fotometrik analizler (küvet testleri)

Filter

 Deuterium lamp for spectrophotometer LLG-uniSPEC

LLG

...

 Reference standard kits Chloride for photometers MD series

Tintometer

The reference standards are used to check the photometric detection accuracy and reproducibility of measurement results. Adjustment of the photometers is not possible with the reference standard kits. When checking the photometers with the reference standard kit, the appropriate method is selected and the measured value in mg/L is compared with the reference value of the standard kit. The shelf life is two years from the date of manufacture if used and stored properly....

 Adhesive tape, glass-fibre reinforced

MACHEREY-NAGEL

Fibre-glass reinforced adhesive tape for sealing hazardous goods cartons....

 Accessories for Photometers PrimeLab 1.0

LLG

...

 Cells for Photometer photoLab®

WTW

Cuvettes for photometric routine and water analytics in the UV-VIS and VIS range. Cells with matt side surface are suitable for the automatic cell detection of the photoLab ® filter and spectral photometer. The glass and quartz cuvettes have a marking in order to place the cuvettes into the photometer in the same direction for an even higher precision....

 Accessories for photometer photoFlex® series and turbidimeters Turb® 430 series

WTW

LabStation with LSdata software for easy data evaluation. The rechargeable battery is included in the delivery.

  • direct export to MS-Excel
  • GLP-conform data transfer
  • calibration curve calculation
  • adjustment between meter and PC
...

 Accessories to Flame Photometer FF-200

Jenway

Please Note: These products will only operate with the correct type of air compressor and gas regulator as specified below....

 Thermoreactor RD 125

Tintometer

Chemical digestion of samples is required for the photometric determination of COD, TOC, total chromium, total phosphate and total nitrogen. The required temperatures and reaction time can be selected by using the membrane keypad of the reactor RD 125. The unit works at three different temperatures (100 / 120 / 150 °C) and three pre-set reaction times (30 / 60 / 120 minutes). When digestion is complete, the reactor automatically switches off and gives a corresponding LED indication with short beep alarm. The RD 125 reactor is fitted with 24 holes for 16 mm diameter vials....

 Reagent Tablets for Photometers and Comparators Lovibond®

Tintometer

...

 Cuvettes for photometers

Tintometer

...

Add to shopping cart