Sıcaklık kontrolörleri, termostatlar

With Schuko power output socket and discrete control circuit. Plastic housing insulated to VDE. Automatic on/off switch. Will not function unless a contact thermometer is plugged in. Switch status display. Dimensions (W x D x H) 120mm x 80mm x 85mm. Switching capacity 220V 10A.

The device is used for moitoring cooling water circuits. Because of the high braking capacity thermostats and cryostats are also connectable. A reliable water flow sensor.

Alternating current controller for variable and no-loss control of resistive and inductive power devices with the following additional features:

• On/off luminous rocker switch, dipole switching, 10 A (4)
• IC controlled, hysteresis free
• Quiet running
• Anti-interference grade N
• Fast-blow fuse
• Protected fuse holder
• Power-on indicator lamp

All probes with 2m connecting cable and plug.

Safety temperature switch for monitoring temperature-based routines of all kinds. Ideal for monitoring simple temperature controllers. The TEMPAT^® Control device switches off when the limit temperature is obtained; a beep is heard. When the temperature drops below limit, the limit contact does not switch on automatically; it must be reset by the user.

For controlling temperature of heating coils, hotplates, ovens, infrared radiators and water baths. TEMPAT^®-D has a 10mm high, LED display which can even be seen in dark rooms and allows monitoring of actual temperature at any time. Set point can be entered via a 3 or 4 figure coding switch with 1°C resolution. Built-in sensor breakdown fuse, switching interval display and Xp trimmer to adjust variable gain amplification between 0 and 10K. Sensor connection is via a plug-in socket.

Appropriate temperature sensor please order separately.
If no temperature sensor is ordered, a loose plug is supplied.

Safety temperature controllers for regulating the temperature of heating coils, hotplates, ovens, infrared radiators and water baths with 7mm high LED display. A coding switch is provided for entering set points. For optimum safety: Irreversible safety contact breaker with secondary sensor input and dipole switch-off in the event of overtemperature or sensor malfunction. Visual and audible alarms. Critical temperature values are set using potentiometer and controlled via the display.

Appropriate temperature sensor please order separately.
For each operating two sensors per thermostat is required. Please order separately.

For power control of heating mantles of the HM series, electric Bunsen burners and heating tapes. Each controller has two neon indicators: White neon "Power On" and amber neon "Mantle/Bunsen Heater On". When the control knob is turned clockwise, the power increases and the amber indicator light begins to pulse. As soon as the maximum power is reached, the lamp lights up continuously. There is a clamp on the rear of the controller for attaching a rod (Ø 12 mm).

LabHEAT^®-sensors. Suitable for temperature control and KM-KM-RX1001 RX1004 with permanently attached cable, with or without diode plug.

KM-TP2: Pt100, up to 400 °C, sheated element V2A, dia. 4 x 50 mm,
KM-TPG: Pt100, up to 250 °C, glass tube, dia. 6 x 40 0mm,
KM-TNS: NiCr-Ni, up to 1200 °C, rod sensor in Inconell, dia. 1.5 x 300 mm
KM-TNF: NiCr-Ni, up to 400 °C, flat sensor, 0.4 x 15 x 400 mm