Özel fotometre

Single channel, low temperature flame photometer for use in industry, medicine and education. Can be operated with propane, butane, natural gas or liquid gas (LPG). With built-in electronic flame failure safety system for operational safety.

• Model PFP7 incl. Na, K, Ca, Ba and Li filters
• Model PFP7/C incl. Na, K and Li filters
• 3 year warranty

Supplied with: Na, K, Li filters (model PFP7/C), additionally Ba and Ca filter (model PFP7), connecting hoses and clips, compressor plug, drain trap, fuses and operating/service instructions

Specifications
Range PFP7: Range PFP7/C: Limits of detection Na/K: Li: Ca: Ba:	0 ... 199.9 ppm 120 ... 160 ppm Na, 0 ... 10 ppm K < 0.2 ppm < 0.25 ppm < 15 ppm < 30 ppm
Reproducibility:	< 1 % (Coefficient of variation for 20 consecutive samples using 10 ppm Na set to a reading of 50)
Linearity:	< 2 % (when concentration of 3 ppm Na/K and 5 ppm Li are set to a reading of 100)
Specificity:	Interference from Na, K and Li equal in concentration to test element will be < 0.5 %
Recorder output:	Nominal 1.00 V for a reading of 100.0
Air:	6 l/min at 1 Kg/cm2 /14psi (oil and moisture free pressurised air)
Dimensions (W x D x H): Weight:	420 x 360 x 300 mm 8 kg
Power supply:	190 ... 250 V, 50/60 Hz

Accessories Accessories to Flame Photometer PFP7

The compact photometer PF-12^Plusis a customized device for mobile water analysis, which is used to evaluate the proven VISOCOLOR^® ECO tests and NANOCOLOR^® tube tests by MACHEREY-NAGEL. This filter photometer with microprocessor control, self-test and auto-calibration is suitable for mobile analytics. It is equipped with more than 100 preprogrammed methods and additional functions. An 860 nm LED allows the nephelometric turbidity measurement in the range of 1 to 1000 NTU. The icon-based menu navigation and the clear task bar make the PF-12^Plusan easy-to-use photometer for all applications in water and waste water analysis. Numerous other variants of the VISOCOLOR^® and NANOCOLOR^® reagent cases are available in combination with the PF-12^Plus.

• With over 100 preprogrammed tests and special methods, extinction, transmission, factor, standard, nephelometric turbidity measurement (NTU-Check), 50 freely programmable methods
• 7 interference filter with a receptacle for an additional filter, 860 nm LED for NTU measurement
• Insensitive to external light for fast measurement without cuvette slot cover
• Xenon high-pressure lamp
• Automatic zero balance
• Fully automatic turbidity control at 90° angle (NTU-Check)
• Free updates

Scope of delivery: Compact photometer PF-12^Plusincl. Software DVD, manual, 4 batteries, 4 empty cuvettes, funnel, cup, syringe, USB cable, calibration cuvette, certificate and cleaning cloth in a sturdy case

Specifications
Optics:	Automatic filter wheel with 7 interference filters
Wavelengths:	345 nm / 436 nm / 470 nm / 540 nm / 585 nm / 620 nm / 690 nm / 860 nm
Wavelength accuracy:	± 2 nm, bandwidth at half transmission 10 ... 12 nm
Photometric range / accuracy:	± 3 A / ± 1 %
Stability:	<0.002 A/h
Data memory:	1000 results, GLP conform
Cuvette slot:	Round cuvettes 16 mm OD
Display:	Backlit graphic display, 128 x 64 pixels
Interface:	USB 2.0
Environmental conditions:	10 ... 40 °C, up to 80 % relative humidity (non-condensing)
Dimensions (W x D x H):	215 x 100 x 65 mm
Weight:	700 g
Power supply:	USB interface, batteries, rechargeable batteries or accu-pack
IP code:	IP 68

The Lovibond^® MD 100 Photometers are designed for analysis of different parameters in drinking water, industrial process water and waste water. With a total of more than 30 different types, instruments are available for routine testing as well as for special applications. The MD 100 uses high quality interference filters with long-life LEDs as a light source without any moving parts in a transparent sample chamber. The units supply accurate, reproducible results very quickly. Other major advantages include ease of operation, ergonomic design, compact dimensions and safe handling. Provided with calibration and software-based adjustment options the MD 100 is suitable for use as a testing instrument. The tests are conducted using either Lovibond^® tablet reagents with long-term stability and a shelf life of 5 or 10 years, VARIO powder reagents or using liquid reagents.

• Optics: High-quality Interference Filters
• Wavelength accuracy: ±1 nm.
• Power supply: 4 micro batteries (AAA), capacity approx. 17 hours or 5000 tests.
• Automatic switch-off.
• LCD Display (backlit on keypress).
• Internal ring memory for 16 data sets.
• Dimensions (L x W x H): 155 x 75 x 35 mm.

Scope of supply: Photometer in a plastic carrying case, with reagents for 100 tests, cells, batteries and standard accessories.
Optional: IRiM - infrared interface module for data transfer to computer or printer.

Alternative Photometers AL100 Boiler Water, Cooling Water

Suitable for calibration, control, IQ / OQ and method validation. Compatible with all Flame Photometry Instruments. Available as single element analytical standards (in ppm) or Multi-element clinical standards (in mmol/l). NIST traceable. HDPE bottles of 500 ml.

The LED Photometer PF-3 with micro processor control for evaluation of pre-programmed NANOCOLOR^® and VISOCOLOR^® ECO tests is ideally suited for mobile operation directly on site in the swimming pool.

• Add new tests and parameters anytime
• Self-test and auto calibration
• Insensitive to external light for fast measurement without cuvette slot cover
• Test selection from parameter lists
• Waterproof and sturdy
• Free software for data export

Scope of delivery: Photometer PF-3 in VISOCOLOR^® reagent case with VISOCOLOR^® ECO Chlorine 2 free + total (liquid), pH 6.0 - 8.2, cyanuric acid, alkalinity TA incl. calibration cuvette, 4 empty cuvettes, sample cup, 5 ml syringe, 3 batteries, manual, booklet "VISOCOLOR^® ECO Test Instructions for Compact Photometer PF-3" and certificate in a sturdy case.

Specifications
Optics:	LED with 3 interference filters
Wavelengths:	450 nm / 530 nm / 590 nm
Wavelength accuracy:	± 2 nm, bandwidth at half transmission 10 ... 12 nm
Data memory:	50 results
Cuvette slot:	Round cuvettes 16 mm OD
Display:	Backlit graphic display, 128 x 64 pixels
Interface:	Mini-USB
Dimensions (W x D x H):	170 x 95 x 68 mm
Weight:	500 g
Power supply:	USB interface, batteries, rechargeable batteries or accu-pack
IP code:	IP 68

VISOCOLOR^® ECO reagent case
For mobile use with test instructions for visual determination, analytical accessories and the following tests:
Ammonium 0.2 - 3mg/L NH₄⁺ / Carbonate Hardness 1 drop = 1.25°e / total hardness 1 drop = 1.25°e / Nitrate 1 - 120mg/L NO₃^- / Nitrite 0.02 - 0.5mg/L NO₂^- / pH 4.0 - 9.0 / Phosphate 0.2 - 5mg/L P

VISOCOLOR^® reagent case for soil analysis
The VISOCOLOR^® reagent case for soil analysis is the perfect companion for economical, fast and convenient soil analysis, both in the field or in your laboratory, including the following tests:
QUANTOFIX^® test strips: Ammonium 10 - 400mg/L NH₄⁺ / Nitrate / Nitrite 10 - 500mg/L NO₃^-/ 1 - 80mg/L NO₂^- / VISOCOLOR^® ECO test kits: Potassium 2 - 15mg/L K⁺ / VISOCOLOR^® HE test kits: pH 4.0 - 10.0 / Phosphate 1.0 - 20.0mg/L P / pH-Fix test strip: pH 2.0 - 9.0

VISOCOLOR^® School reagent case
The VISOCOLOR^® SCHOOL reagent case is especially designed for schools and caters to the needs of both students and teachers. All reagents are approved to be used in schools in Germany (GUV - SR 2004 directive) and can be disposed of easily just down the drain without any harm to the environment.
Ammonium 0.2 - 3mg/L NH₄⁺, Nitrate 1 - 90mg/L NO₃^-, Nitrite 0.02 - 0.5mg/L NO₂^-, Phosphate 0.5 - 15mg/L P, pH pH 4.0 - 9.0, Total hardness 1 drop = 17.8mg/L CaCO₃

VISOCOLOR^® Reagent case for environmental analysis with photometer PF-12^Plus:
User guidance in 12 languages (DE, EN, FR, ES, IT, NL, HU, PL, PT, CZ, ID, SL, TR, MY)
For determination of VISOCOLOR^® ECO Ammonium 15, VISOCOLOR^® HE Carbonate hardness C 20, VISOCOLOR^® ECO Iron 2, VISOCOLOR^® HE total-Hardness H 20 F, VISOCOLOR^® ECO Nitrate, VISOCOLOR^® ECO Nitrite, VISOCOLOR^® ECO pH 4.0-9.0 and VISOCOLOR^® ECO Phosphate

Specifications PF-12Plus: Light source: Detector:	Xenon lamp Silicon photo-element
Display:	Backlit graphic display, 128 x 64 pixels All important data at a glance: Result in respective unit, date, time, sample number, sample location and dilution
Operation:	Display user guidance, plastic foil keyboard Test selection via parameter lists.
Accuracy: Long-term stability: Interface:	±1% < 0.002A/h USB 2.0
Power supply:	Via USB power supply, standard or rechargeable batteries or Akkupack
Dimensions: Weight:	215 x 100 x 65mm 0.7kg

Reflectance photometer for the evaluation of test strips
Programmed for QUANTOFIX test strips. The system simplifies testing procedures and the decision processes by eliminating the subjectivity of visual readings and by providing higher accuracy.

• Touch-Display
• 5 methods preset, any other methods can be selected
• Autostart function
• Measured value output in the display
• Fixed power supply and battery operation
• Memory for 200 measurements
• No gradation and estimation of in-between values is necessary
• Very simple operation, precise results
• Printing and data transfer, simple documentation
• Output of intermediate values

Specifications
Dimensions (W x D x H ):	160 x 200 x 75 mm
Weight:	710 g
Power requirements:	Netzteil 110 ... 240 V AC Batteriebetrieb mit 6 AA Batterien