Hotplates

LabHEAT^®-Heating elements for flasks, round bottom. Serial heating unit in plastic coated, chemical-resistant metal housing with six heating positions. Each heating position is separately controlled via controller, 1.5m supply (earthed) cable and RCD (residual current detection); nominal voltage 230V AC. Dimensions (W x D x H): 1150 x 290 x 150 mm.

Electronic alternating current adjuster for easy control of resistance power equipment such as hotplates, soldering irons, light bulbs, infrared radiators, universal motor speed regulators, stirrers etc. With high rating fuse, 2 pin on/off luminous rocker switch and shielded, fused Schuko socket.
Adjustment 10 to 230 V, fitted with an interference suppressor in accordance with EN standard.

Thickness 3,8 mm, chamfered edges. Usable above open burner flame. Ideal as heating surface in place of a wire gauze or pipeclay triangle.

For continuous operation. Electric hotplates with thermostatic temperature control and separate power controller for performance adjustment to the heating requirements. Anodised aluminium alloy hotplate. Excellent uniform temperature distribution over entire heating surface. Asbestos free. Stainless steel housing, with painted central section. Height-adjustable feet. Mains cable approximately 1.7 m. With earthed plug for 230 V supplies up to 3300 W. A 400V 3-phase model is also available.

For continuous operation. Electrical sand baths with thermostatic temperature control and separate power controller for performance adjustment to the heating requirements. Anodised aluminium alloy hotplate. Excellent uniform temperature distribution over the entire heating surface. Asbestos free. The sand bath frame is tightly screwed onto the hotplate so that the sand is in direct contact with the hotplate. Useful depth 50 mm. Stainless steel controller housing, with painted central section. Height-adjustable feet. Connection cable approximately 1.7 m. With earthed plug for 230 V supplies up to 3300 W. A 400V 3-phase model is also available.

LabHEAT^®-Heating elements for flasks, round bottom. Serial heating unit in plastic coated, chemical-resistant metal housing (W x H x D) 580 x 150 x 290 mm with three heating positions. Each heating position is separately controlled via controller, 1.5 m supply (earthed) cable and RCD (residual current detection); nominal voltage 230 V AC.

The multi position (extraction) mantle has a built-in electronic controller and offers a choice of heater only (EME) or heater/stirrer (EMEA) combination. The vented case"s unique air flow ensures the outer case remains safe to touch.

• Individual built-in solid state electronic controls enable easy regulation of heater, while removing sparking associated with mechanical switching
• Three 12.7 mm diameter support rods are included
• Round bottom flask capacity from 100 ml to 1000 ml at all positions
• Top cover is polypropylene and external surfaces are powder coated giving good general chemical resistance
• Coiled heating element is suspended within a thermal insulating cartridge to provide maximum heat transfer and support
• Earth (ground) screen encloses the heater for added safety
• Individual heater cartridges are replaceable
• Neon lights indicate when power is on and supplied to heaters and, if applicable, supplied to stirrers

• Allow the solution to be stirred and heated simultaneously
• Provide stirring speeds of between 50 to 1000 rpm
• One stirring control operates each set of three recesses