Zinc-plated steel wire with pipeclay tubes.

Steel, powder-coated. With an M10 bore hole in the middle of one of the shorter sides. Laboratory stands are supplied without support rod. Please select the suitable rod from "support rods".

Steel. With or without bosshead, as outlined below.

Bunsen burner with needle valve DIN (NG-2411 BO0031).

Bunsen burner with needle valve and pilot flame DIN (NG-2411 BO0031).

Bunsen burner with stopcock and pilot flame DIN (NG-2411 BO0032)

Burette clamp with boss, nickel plated brass, for 1 burette.

Burette clamp with boss, nickel plated brass, for 2 burettes.

Burette roller clamp with boss, for 1 burette, epoxy coated.

Burette roller clamp with boss, for 2 burettes, epoxy coated.

Chain clamps malleable iron, epoxy coated, with brass chain.

To DIN 12894. Stand clamp rounded jaws, epoxy coated.

With Schuko power output socket and discrete control circuit. Plastic housing insulated to VDE. Automatic on/off switch. Will not function unless a contact thermometer is plugged in. Switch status display. Dimensions (W x D x H) 120mm x 80mm x 85mm. Switching capacity 220V 10A.

The device is used for moitoring cooling water circuits. Because of the high braking capacity thermostats and cryostats are also connectable. A reliable water flow sensor.

Brass, with handles.

The heating bath HB 1500 is developed for varied tasks. The bath can be filled with water, oil or sand. Modern microprocessors control the temperature. With measuring circuit monitoring for over- and under-temperature, sensor and line short-circuit, as well as sensor and line breakage.

• Microprocessor controller with 4-digits 7-segment display, 10 mm high, green
• Freely configurable
• Self-optimising temperature control
• Measuring and control range up to 260 °C
• Setting of heating power from 1 to 99 %
• Overtemperature switch-off >10 K + setpoint
• Wear-free internal temperature sensor at the bottom of the pot
• On-Off switch 2-pole, green, illuminated
• Switchable to external sensor
• Material bath/housing stainless steel, front and rear anodised aluminium

The heating bath HB 1500-S is developed for varied tasks. The bath can be filled with water, oil or sand. The appliance is equipped with 2 temperature controllers with microprocessor. The upper temperature controller serves as a safety temperature limiter. If the safety temperature is exceeded, the heating is switched off at all poles. The temperature is measured via an internal temperature sensor at the bottom of the pot.

• Microprocessor controller with 4-digit 7-segment display, 10 mm high, green
• Freely configurable
• Self-optimising temperature control
• Measuring and control range up to 260 °C
• Setting of heating power from 2 to 99 %
• Switchable to external sensor
• Material bath/housing stainless steel, front and rear anodised aluminium

Hook bosshead steel, epoxy coated or stainless steel. With nickel plated brass spade thumb screw M8.

-Easy and safe lifting

• With ball-bearings in the guide rails
• Stable, parallel movement

• Easy and safe lifting
• With ball-bearings in the guide rails
• Stable, parallel movement
• Scissor system made of steel
• Top-/ base plate made of aluminium

With lobe screws.

Teclu burner with stopcock and pilot flame DIN (NG-2411 BO0033)

With epoxy coating, for 1 burette.

The large handwheel ensures that the loads can be lifted slightly.

• High stability
• Powder coated